The Telos Alliance revolutionized the modern broadcast facility with the invention of Audio over IP. We proudly extend the AoIP revolution we began in the studio out to the transmitter with the Omnia MPX Node. Like its namesakethe classic Axia xNodeOmnia MPX Node is a building-block technology that helps stations leverage the growing power and capability of data networking. The Omnia MPX Node is the first purpose-built hardware codec capable of sending or receiving full FM signals at data rates as low as 320 kbps utilizing the Omnia MPX algorithm, ideal for networks with limited capacity (including IP radios). MPX Node makes peak-controlled L/R baseband, stereo pilot, and RDS data routable from a studio to one or many FM transmitters. By transporting an FM composite signal rather than left/right audio, broadcasters can keep their on-air processing and RDS encoding at the studio, then deliver a transmission-ready, peak controlled FM multiplex signal directly to an FM transmitter without the need for transmitter-side peak limiting or stereo generation. The MPX Node is available as either an encoder or decoder, and a pair of units creates an end-to-end system.Main Features:MPX Node is available as either an Encoder or DecoderOmnia MPX algorithm can transport FM composite (MPX) and RDS/RBDS at 320 kbpsperfect for IP radios and DSL IP circuits and other lower bandwidth connectionsEncoder can be fed by any brand of FM audio processorOmnia.9 or OmniaSST processing software can serve as the Encoder front endMPX Node Decoder outputs a standard analog MPX signal to feed any FM transmitterFull FM signals (including RDS/RBDS) can be sent over IP networks5 In x 5 Out GPIOA single Encoder can transmit the same signal to multiple decodersSimple HTML.5-based web GUI allows you to control MPX Node from your desktop, tablet, or smartphoneCool-running, fanless operationSeparate Ethernet ports for MoIP transport and web adminDual bank firmware update design, for secure upgradingHalf RU, xNode form factorIntegrated test signal generatorFM tilt correctionSpecifications:Analog composite FM in/out on (BNC connector)Composite connector impedance 5 or 75 ohm (switch selectable)10/100 Ethernet for web control and administration10/100/1000 Ethernet for MoIP connections5 in x 5 out GPIO on a DB15 connector100-240 VAC input 50-60 Hz external power supply with 12VDC, 3.4A output on locking connector8.5 (22 cm) wide; two may be mounted side-by-side in a standard 1RU rack space with accessory mounting kit; 1.72 (4.4 cm) height, 11.75 (30 cm) depthOperating temp range 0 to +40 degrees C, <90% humidityShipping weight 7 lbs. (3.2 kg.)