The IF-AN16/OUT is an optional 16-channel analog output interface card for the TASCAM expansion slot system. Equipped with two D-sub 25 pin for analog outputs.Supporting models : TASCAM Sonicview 24XP / TASCAM Sonicview 16XP / DA-6400 / DA-6400dpMain Features:16 channels of analog outputsBuilt-in output attenuation for each channel: 0 to -14dB (0.5steps)Two 8-channel D-sub 25pin balanced audio signal outputs (channels 1-8 and 9-16)Compatible with the TASCAM Expansion Slot systemSpecifications:Formats and channels: 16 channels at 44.1/48/88.2/96kHz, 16-bit/24-bitAnalog audio output ratingsANALOG 1-8/9-16 OUT connectors:-Connector: D-Sub 25pin-Locking screws: No.4-40 UNC (inch type)-Nominal output levels: +4 dBu, +6 dBu (only when maximum output level is +15 dBu)-Maximum output levels: +24 dBu, +22 dBu, +20 dBu, +18 dBu, +15 dBu (Switched according to nominal level of device installed in)-Output impedance: 200 or lower-Output attenuation: 0 to -14 dB (in 0.5dB steps)Dimensions: 107(W) 40(H) 161.5(D) mm (including protrusions)Weight: 240gFrequency response:+0.1dB/-0.5dB : 20Hz/20kHz (-16dBFS input, 44.1/48kHz sampling frequency, JEITA)+0.1dB/-1.0dB : 20Hz/40kHz (-16dBFS input, 88.2/96kHz sampling frequency, JEITA)Distortion (THD+N): 0.001% or less (0dBFS input, 1kHz, 44.1/48/88.2/96kHz sampling frequency, JEITA):S/N ratio: 110dB or higher (44.1/48/88.2/96kHz sampling frequency, JEITA)Dynamic range: 110dB or higher (44.1/48/88.2/96kHz sampling frequency, JEITA)Crosstalk: 110dB or higher (1kHz, 44.1/48/88.2/96kHz sampling frequency, JEITA)