This Qwiic/STEMMA connector from Ozzmaker allows you to easily connectQwiic or STEMMA enabled modules to a Raspberry Pi, without the need for soldering.

It uses a 2×3 pin female header which sits on top of the first 6 GPIO pins and breaks out the 3.3v, GND and the two I2C pins (SDA, SCL) on a 4 pin JST connector which sits on top.

Works great with theBerryGPS-IMU!

The cable is 7.87″ / 20cm in length.

Package contents

• 1 x Qwiic connector
• 1 x Qwiic cable

Note: Raspberry Pi and BerryIMU are not included.