[email protected] Free Shipping On Orders Over $40

Shopping Cart

Small OLED modules are a popular option for adding a simple display to your project for monitoring data, displaying IP addresses, weather, counters or anything else you decide to code!

This 0.96″ module is small, lightweight and features a convenient horizontal pin header for wiring up to your microcontroller.

The convenient mounting holes make it easy to embed this display to a custom enclosure for your project.

Resources

  • Product Wiki and user guide
  • Code examples

Tech Specs

DRIVER CHIP SSD1306
INTERFACE 3-wire SPI, 4-wire SPI, I2C
RESOLUTION 128*64
DISPLAY SIZE 0.96inch
COLORS 1/4 yellow section, 3/4 blue section
VISIBLE ANGLE >160
OPERATING TEMP. () -20~70
STORAGE TEMP. () -30~80
OPERATING VOLTAGE 3.3V / 5V
APPLICABILITY Hardware platforms such as Raspberry Pi/Jetson Nano/Arduino/STM32

Interface

PIN NO. SYMBOL DESCRIPTION
1 VCC Power positive (3.3~5V power input)
2 GND Ground
3 NC NC
4 DIN Data input
5 CLK Clock signal input
6 CS Chip selection, low active
7 D/C Command signal, low level for command, high level for data
8 RES Reset signal, low active

Hardware Configuration

MODE/INTERFACE BS0/BS1 DIN SCK
3-wire SPI 1/0 MOSI SCLK
4-wire SPI 0/0
I2C 0/1 SDA SCL
Add a Review

Your email address will not be published. Required fields are marked *

Related Products