These chrome-plated metal buttons are rugged and look real good while doing it! Simply drill a 16mm hole into any material up to 1/2″ thick and you can fit these in place, there’s even a rubber gasket to keep water out of the enclosure. On the front of the button is a flat metal actuator, surrounded by a white plastic LED ring. On the back there are 3 contacts for the button (common, normally-open and normally-closed) and 2 for the white LED ring (+ and -). Connect 3 to 6V to the LED to have it light up nicely, there’s a built in resistor! If you want to use this with a higher voltage, say 12V or 24V, simply add a 470 ohm resistor in series with the LED connection to keep the LED current at around 20mA.

This button is a momentary push button, when you press it the ‘normally-open’ contact shorts to the common contact. When you release it, the contacts open up again.

The switch and LED are separated, so you could wire it to turn on when pressed or vice versa or whatever you wish!

Grab a pack of our 2.8mm Quick-Connect Wire Pairs to wire these up!

Technical Details

• Drill hole diameter: 16mm
• Switch rating: 3A / 250VDC
• Switch contacts: 1 NO, 1 NC
• Material: Chrome plated brass
• Contact resistance: < 50 mOhm
• Insulation resistance: > 1000 Mohm
• Temperature: -20 C to +55 C
• Mechanical life: > 500,000
• Electrical life: > 50,000
• Panel thickness: 1-13mm
• Operating pressure: 1.5 – 2.5 N
• Operating stroke: 2mm
• Lamp rated voltage: 6V

These chrome-plated metal buttons are rugged and visually appealing. Simply drill a 16mm hole into any material up to 1/2″ thick to fit this pushbutton, which includes a rubber gasket to keep water out of the enclosure.

The button features a flat metal actuator on the front, surrounded by a white plastic LED ring. On the back are 3 contacts for the button (common, normally-open, and normally-closed) and 2 contacts for the white LED ring (+ and -). The LED can be powered by 3 to 6V with a built-in resistor for safe illumination. For higher voltages like 12V or 24V, add a 470 ohm resistor in series to maintain a current around 20mA.

This is a momentary pushbutton: pressing it shorts the normally-open contact to common, and releasing it opens the contacts again. The switch and LED are separated for versatile wiring options.

• Drill hole diameter: 16mm
• Switch rating: 3A / 250VDC
• Switch contacts: 1 NO, 1 NC
• Material: Chrome plated brass
• Contact resistance: < 50 mOhm
• Insulation resistance: > 1000 Mohm
• Temperature range: -20C to +55C
• Mechanical life: > 500,000 cycles
• Electrical life: > 50,000 cycles
• Panel thickness supported: 1-13mm
• Operating pressure: 1.5 – 2.5 N
• Operating stroke: 2mm
• Lamp rated voltage: 6V

Arcade Button Quick-Connect Wire Pairs – 0.11″ (10 pack) recommended for easy wiring.