Description:

The AD9850 is a highly integrated device that uses advanced DDS technology coupled with an internal high speed, high performance, D/A converter and comparator, to form a complete digitally programmable frequency synthesizer and clock generator function.

DDS Function Generator Module all the external components which are needed are integrated on the board and the designer dont need to care more about the detailed design of ADS9850. The designer only needs to add the power and control signals to driver this module

Specification:

• Operating Voltage: 3.3 6 Volts
• Oscillator Frequency: 125 MHz
• Output Frequency: 0 40 MHz
• Operational Temperature: -40 850C
• Source/Sink Continuous Current: 0.005 Amperes
• DAC Current: 0.03 Amperes
• Power Dissipation(125 MHz, 5V): 380 mWatts
• Power Dissipation(110 MHz, 3.3V): 110 mWatts

Features:

• DAC with Spurious Free Dynamic Range to specify the generators performance
• It contains a power-down function for a short boot time.
• Data transmission can either be parallel or serial.
• Power Dissipation depends on the power supply voltage.
• Four Analog signal outputs i.e., Sine-Wave 1, Sine-Wave 2, Square-Wave 1, and Square-Wave 2
• A comparator to generate less jittering in square wave output
• Direct Digital Synthesizer is based on CMOS Technology for better functionality and performance.
• A small high-performance module with a surface-mount package to be operated at industrial temperature

Pin Description:

• VCC: Supply pin
• D0-D7: Data input pin
  
• GND: Reference potential pin
• W-CLK: Word Load Clock pin
• FQ-UD: Frequency Update pin
• Data: Serial data input through D7 pin
• Reset: Master reset pin
• Sine-Wave 1: DAC Current Output pin
• Sine-Wave 2: DAC Current Output pin
• Square-Wave 1: DAC Complementary Output pin
• Square-Wave 2: DAC Complementary Output pin

• Input/Output pins:These are 8-bit data pins used to load data up to 32-bit frequency and 8-bit phase/control word. D7(MSB) also serves the purpose of loading a 40-bit serial data word.
• W-CLK:A Word Load Clock is used to synchronize and load words serially or through parallel transmission.
• FQ-UD:Frequency Update is used to update the frequency in the input data register when the clock has a rising edge. After updating, it reset the pointer to the word 0
• DATA:This pin is connected to the D7 input pin. It is used to load serial data.
• RESET:A master RESET is used to clear all the registers except for the ICs input register by putting it into a HIGH state. Moreover, the outputs of DAC will be converted to Cosine 0 after some clocks.

Useful Link:

• AD9850 DDS Signal Generator Module Datasheet

Package Included:

1 x AD9850 DDS Signal Generator Module DDS Function Generator Module AD9850 Direct Digital Synthesizer Module For Electronics Projects