Little clicky switches are standard input buttons for electronic projects. The STEMMA Wired Tactile Push-Button Pack features five tactile push-buttons, each assembled onto a PCB with a pull-up resistor installed. The pins are normally open and momentarily close when pressed.

Each button is topped with a colorful round cap in blue, white, yellow, red, and black.

• Each button board includes a JST-PH 2mm connector and a matching JST PH 3-Pin to Male Header Cable (200mm) for easy wiring.
• Connect the black wire to ground, white wire to the input signal pin, and red wire to power (3V or 5V) to activate the pull-up resistor.
• Compatible with Arduino, CircuitPython, Raspberry Pi, and other DIY builds.
• Optionally connect using alligator clips with the STEMMA to Gator cable or directly to STEMMA 3-pin connectors using a compatible cable.

This pack is perfect for projects needing tactile inputs with simple wiring and colorful buttons.

Technical Details

• Single button PCB dimensions: 28mm x 21mm x 14mm
• Red wire: Power (3 to 5V DC)
• White wire: Signal output, pulled high to red wire with 10K resistor, connected to ground when pressed
• Black wire: Signal and power ground